Changes to Step #4
Edit by Robert Kirk —
Edit approved by Robert Kirk
- Before
- After
- Unchanged
Step Lines
| + | [* black] INSTALL THE MOTOR AND PULLEY |
|---|---|
| + | [* black] Install pulley onto motor shaft, verify one set screw is aligned with the flat on the motor shaft. |
| + | [* black] Install motor onto X motor mount using 4x M3 x 12 SHCS and M3 washers. |
| + | [* black] Take note of the alignment of the motor wires. |
| + | [* black] Verify Assembly is complete. |
Image 1
No previous image
Added
Image 2
No previous image
Added