Changes to Step #3
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Tack shaker bolts to hopper support |
|---|---|
| + | [* black] Place the shaker onto the bolts already welded to the hopper supports. |
| + | [* black] Clamp the other side to the hopper support. |
| + | [* black] Use a square to make sure the shaker mount is square with the hopper supports. |
| + | [* black] Tighten nuts onto the side with the welded bolts. |
| + | [* black] Tack the bolts to the hopper support. |
| + | [* black] Make sure you tack them to the hopper support, NOT the shaker mount. |
| + | [* black] Tack as much as you can from this position. |
Image 1
No previous image
Added
Image 2
No previous image
Added