Changes to Step #2
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Install hopper supports and prepare shaker mount. |
|---|---|
| + | [* black] Install the hopper supports into the leg holders. |
| + | [* black] Make sure you put the support with bolts on it on the correct side (refer to your shaker motor and look where you marked it.) |
| + | [* black] Their bottom side should be flush with the bottom of the leg holders on the frame. |
| + | [* black] Make sure they are orientated correctly. See photo. |
| + | [* black] On the side of the shaker motor that you didn't weld bolts for, put a bolt (3/4"x1.5") thru both holes and tighten nuts onto them. |
| + | [* black] The nut should be on the side of the mount that the motor will be installed to. (see photo) |
Image 1
No previous image
Added
Image 2
No previous image
Added