Changes to Step #12
Edit by Robert Kirk —
Edit approved by Robert Kirk
- Before
- After
- Unchanged
Step Lines
| + | [* black] INSTALL THE X BELT (continued) |
|---|---|
| + | [* black] Pull tight and clamp down with a M3 x 12 SHCS and M3 Washer. |
| + | [* black] Trim the ends of the belt so they do not interfere with the pulley or bearings. |
| + | [* black] Check for belt rubbing as you move the X carriage back and fourth. Adjust as necessary. |
| + | [* black] Is the belt nice and tight? |
| + | [* black] Does the belt rub anywhere? |
Image 1
No previous image
Added