Changes to Step #8
Edit by Robert Kirk —
Edit approved by Robert Kirk
- Before
- After
- Unchanged
Step Lines
| + | [* black] INSTALL LEFT DRIVE ROD |
|---|---|
| + | [* black] Push the end of the coupler tube down onto the Motor shaft. |
| + | [* black] Lift up the X/Z axis until you can bolt the Z nut holder to the X end motor. |
| + | [* black] Using 4x M3 x 12 SHCS and M3 Washers, attach the Z nut holder to the X end motor. |
| + | [* black] Install large zip ties on the end of the drive rod and on the motor shaft as shown. |
| + | [* black] he zip does must be tight enough that you can't pull the drive rod off vertically. |
| + | [* black] Did you pull up on the drive rod to check the zip ties? |