Changes to Step #2
Edit by Chris Reinhart —
Edit approved by Chris Reinhart
- Before
- After
- Unchanged
Step Lines
| + | [* black] Mark 1/2" from the end of each 4x4. |
|---|---|
| + | [* black] Transfer the line to two of the other sides in a similar manner to step 1. |
| + | [* black] Set your circular saw blade to a 45 degree angle as seen in photo 2. |
| + | [* black] Bevel 3 of the sides by using the angled blade to cut along the line. The result will look like photo 3. |
| + | [* black] The fourth side does not get beveled because it lays flush against the wall. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added