Changes to Step #4
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
| + | [title] Move the drawer and re-adjust bolts |
|---|---|
| + | [* black] Move the drawer to the fully extended position. |
| + | [* black] The drawer will likely get stuck along some points of its travel. Its OK to hit it with a hammer. Remember the secondary cylinder will be applying tons of force to move it. |
| + | [* black] If you need to hammer it REALLY hard, either your drawer is hitting something, or the rollers are too tight on the rails. Investigate the cause. |
| + | [* black] When the drawer is in position, check the rollers again. They should all still be touching the rails. |
| + | [* black] If one is below the rail, tighten the bolt so the rail and roller are touching. |
Image 1
No previous image
Added