Changes to How to Module - Extruder Assembly Introduction
Edit by Robert Kirk —
Edit approved by Robert Kirk
- Before
- After
- Unchanged
Tools
- 1.5mm Allen Driver x1 removed.
- 2.5mm Allen Driver x1 removed.
- 13mm Wrench x1 removed.
Parts
- Extruder Body x1 removed.
- Extruder Idler with 608 bearing installed x1 removed.
- Extruder Washer x1 removed.
- Large Herringbone Gear with Hobbed Bolt x1 removed.
- Small Herringbone Gear x1 removed.
- Extruder Latch x1 removed.
- Extruder Spring x1 removed.
- Motor - 2 x1 removed.
- 608 Bearing x1 removed.
- M3 x 6mm Set Screw x1 removed.
- M3 x 12 SHCS x1 removed.
- M3 x 25 SHCS x1 removed.
- M3 Nut, Zinc x1 removed.
- M3 Washer x1 removed.
- M4 x 55 SHCS with Thumb Screw Knob x1 removed.
- M4 Nut, Zinc x1 removed.
- M4 Washer x1 removed.
- M8 Nylon Nut x1 removed.
- M8 Washer x1 removed.
- M8 Shim Washer 0.5 x1 removed.
- M8 Shim Washer 1.0 x1 removed.
Steps
Step #: 1
Before
After
Step #: 2
Before
After
