You're viewing a previously published revision of this guide.  View latest revision

Older
Apr 10, 2015 - 02:04:39
Apr 10, 2015 - 02:04:39 Apr 10, 2015 - 02:04:39 Feb 16, 2015 - 06:02:39 May 08, 2013 - 12:05:23 May 08, 2013 - 12:05:23 May 08, 2013 - 12:05:21 May 08, 2013 - 12:05:16 May 08, 2013 - 12:05:15
Newer

Roller Guides

Written By: Dozuki System
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

Flags

1

User-Contributed Guide

User-Contributed Guide

This guide is not managed by the site's staff.

Introduction

Sketchup ModelNote: Model doesn't show the proper bolts for the bearings.Additional Materials Required:* V-Groove Bearings (2)* 1/2"x 2.5" Bolts (2)* M12x55mm Bolts (4)* M12 Nuts (4)* Washer, Lock 12mm (8)

    • Grind off the top of the 12mm bolts so that the head is 1/4” thick or less.

    • This is so that the bolts will not be touching the drawer as it slides in and out.

  2. Punch the holes in the main plates and the spacer plates. Weld the 1/2" bolts in the center hole, from the bolt head side. Weld the 1/2" bolts in the center hole, from the bolt head side.

    • Punch the holes in the main plates and the spacer plates.

    • Weld the 1/2" bolts in the center hole, from the bolt head side.

  3. Assemble the bearings to the plate as shown, with lock washers on each side of the main plate. Assemble the bearings to the plate as shown, with lock washers on each side of the main plate.

    • Assemble the bearings to the plate as shown, with lock washers on each side of the main plate.

Author

Dozuki System

Member since: 09/24/2009

1 Reputation

34 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 373