You're viewing a previously published revision of this guide.  View latest revision

Older
Feb 18, 2014 - 10:02:02
Mar 27, 2014 - 03:03:36 Mar 27, 2014 - 03:03:32 Feb 18, 2014 - 10:02:14 Feb 18, 2014 - 10:02:50 Feb 18, 2014 - 10:02:18 Feb 18, 2014 - 10:02:02 Feb 18, 2014 - 10:02:01 Feb 18, 2014 - 10:02:44 Feb 18, 2014 - 10:02:37 Feb 18, 2014 - 10:02:42 Feb 18, 2014 - 10:02:42 Feb 18, 2014 - 10:02:01 Feb 18, 2014 - 10:02:38 Feb 18, 2014 - 10:02:29 Feb 18, 2014 - 10:02:29 Feb 18, 2014 - 10:02:20 Feb 18, 2014 - 10:02:55 Feb 18, 2014 - 10:02:35 Feb 18, 2014 - 10:02:22 Feb 18, 2014 - 10:02:27 Feb 18, 2014 - 10:02:59 Feb 18, 2014 - 10:02:59 Feb 18, 2014 - 10:02:20
Newer

Installing Module - X End Motor

Written By: Robert Kirk
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

4

Time Required

Suggest a time??

Sections

1

Flags

2

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

Private

Private

This guide will not appear in search results and can only be viewed by team members!

Quiz

0

  1. GATHER THE PARTS FOR THE X END MOTOR 1.27mm Allen Driver

    • GATHER THE PARTS FOR THE X END MOTOR

    • 1.27mm Allen Driver

    • 2.5mm Allen Driver

  2. INSTALL THE DOUBLE BEARING HOLDER Assemble the double bearing holder onto the X motor mount with 4x M3 x 12 SHCS and washers.

    • INSTALL THE DOUBLE BEARING HOLDER

    • Assemble the double bearing holder onto the X motor mount with 4x M3 x 12 SHCS and washers.

    • Leave the bearing holder loose at this point.

    • Does the bearing holder wiggle around?

  3. INSTALL THE Z SWITCH ADJUSTMENT SCREW Install the Z switch adjustment screw, with spring and M3 Washer.

    • INSTALL THE Z SWITCH ADJUSTMENT SCREW

    • Install the Z switch adjustment screw, with spring and M3 Washer.

    • INSTALL THE MOTOR AND PULLEY

    • Install pulley onto motor shaft, verify one set screw is aligned with the flat on the motor shaft.

    • Install motor onto X motor mount using 4x M3 x 12 SHCS and M3 washers.

    • Take note of the alignment of the motor wires.

Author

Robert Kirk

Member since: 4/28/13

2,008 Reputation

24 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 5

All Time: 136