Installing Module - Frame XZ Assembly

GATHER PARTS FOR FRAME XZ ASSEMBLY

3mm Allen Driver

Side Cutter

Zip Tie Gun

1.5mm Allen Driver 2.5mm Allen Driver 4mm Allen Driver

INSTALL RIGHT Z MOTOR

Install a Motor -2 using 4x M3 x 12 SHCS and M3 washers.

Take note of wire orientation.

INSTALL LEFT Z MOTOR

Install a Motor -1 using 4x M3 x 12 SHCS and M3 washers.

Take note of wire orientation.

INSTALL SMOOTH ROD AND X END MOTOR

Slide a 10mm smooth rod up through the bottom of the left Z motor mount.

Once you get it started, put the X end motor onto the 10mm rod.

Slide the rod in until the end is flush with the top of the Z top flat plate.

Use a M3 x 6 set screw to secure the rod in place.

INSTALL SMOOTH ROD AND X END IDLER

Slide a 10mm smooth rod up through the bottom of the right Z motor mount.

Once you get it started, put the X end idler onto the 10mm rod.

Slide the rod in until the end is flush with the top of the Z top flat plate.

Use a M3 x 6 set screw to secure the rod in place.

INSTALL X CARRIAGE AND GUIDING RODS

Slide a 10mm rod through one of the two holes in the X end idler.

Once its through far enough, put the X carriage on the rod.

Finish sliding the 10mm rod through until it's also inserted into the X end motor.

The rod will be flush with the outside of the X end motor.

Repeat with the second 10mm rod in the second set of holes.

INSTALL X CARRIAGE AND GUIDING RODS (continued)

Using 4 M3 x 12 SHCS, lock the rods in place at the X ends.

Tighten the bolts holding the bearing holders on the X carriage making sure it still slides freely back and forth.

Tighten the bolts holding the double bearing holders on the X ends at this point as well.

Does the x carriage slide smoothly back and fourth?

Did you tighten all the bearing holder bolts?

INSTALL LEFT DRIVE ROD

Push the end of the coupler tube down onto the Motor shaft.

Lift up the X/Z axis until you can bolt the Z nut holder to the X end motor.

Using 4x M3 x 12 SHCS and M3 Washers, attach the Z nut holder to the X end motor.

Install large zip ties on the end of the drive rod and on the motor shaft as shown.

he zip does must be tight enough that you can't pull the drive rod off vertically.

Did you pull up on the drive rod to check the zip ties?

INSTALL RIGHT DRIVE ROD

Push the end of the coupler tube down onto the Motor shaft.

Adjust the height of the Z nut holder by spinning it to get it close in height to the X end idler.

Using 4x M3 x 12 SHCS and M3 Washers, attach the Z nut holder to the X end idler.

Install large zip ties on the end of the drive rod and on the motor shaft as shown.

The zip must be tight enough that you can't pull the drive rod off vertically.

Did you pull up on the drive rod to check the zip ties?