You're viewing a previously published revision of this guide. View latest revision

Nov 06, 2013 - 07:11:23

Nov 19, 2013 - 10:11:38 Nov 08, 2013 - 06:11:52 Nov 08, 2013 - 06:11:49 Nov 08, 2013 - 01:11:10 Nov 08, 2013 - 01:11:07 Nov 06, 2013 - 07:11:32 Nov 06, 2013 - 07:11:08 Nov 06, 2013 - 07:11:03 Nov 06, 2013 - 07:11:25 Nov 06, 2013 - 07:11:17 Nov 06, 2013 - 07:11:01 Nov 06, 2013 - 07:11:05 Nov 06, 2013 - 07:11:42 Nov 06, 2013 - 07:11:32 Nov 06, 2013 - 07:11:05 Nov 06, 2013 - 07:11:36 Nov 06, 2013 - 07:11:17 Nov 06, 2013 - 07:11:57 Nov 06, 2013 - 07:11:25 Nov 06, 2013 - 07:11:14 Nov 06, 2013 - 07:11:48 Nov 06, 2013 - 07:11:03 Nov 06, 2013 - 07:11:47 Nov 06, 2013 - 07:11:30 Nov 06, 2013 - 07:11:16 Nov 06, 2013 - 07:11:01 Nov 06, 2013 - 07:11:43 Nov 06, 2013 - 07:11:18 Nov 06, 2013 - 07:11:04 Nov 06, 2013 - 07:11:36 Nov 06, 2013 - 07:11:23 Nov 06, 2013 - 07:11:07 Nov 06, 2013 - 07:11:49 Nov 06, 2013 - 07:11:32 Nov 06, 2013 - 07:11:20 Nov 06, 2013 - 07:11:59 Nov 06, 2013 - 07:11:37 Nov 06, 2013 - 07:11:20

Newer

OSE Lasersaur Frame Gantry

Written By: Robert Kirk (and one other contributor)

Comments: 0
Favorites: 0

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Step 1 OSE Lasersaur Frame Gantry

Take the 4x8 cm extrusions and 4x4 extrusions and make a box.
Take a FreeCAD image snapshot here and throughout.

Step 2

Start by taking the 4080 extrusions - the short sides - and mounting the corner brackets to them.

Step 3

Take a corner bracket. Use the corner bracket with the ridge in the middle.

Step 4

Put in 4 spring nuts. Note that these may be inserted from the top of the rail, not necessarily from the side. Use 4 of these per corner bracket.

Step 5

Detail of spring nut. it has a sprung ball on the back side.

Step 6

Mount the first bracket on a corner. Put the short side of the bracket on the short frame side, and the long side of the bracket on the long side. Do not tighten yet.