Difficulty
Moderate
Steps
4
Time Required
- CEB Support System 4 steps
User-Contributed Guide
This guide is not managed by the site's staff.
Introduction
This guide explains the steps for:* Leg Holders-Model* Feet- Model* Legs- Model* Secondary Arms- Model* Primary Arms- Left Primary Arm Model, Right Primary Arm ModelAdditional Materials Required:* 3/4" Steel Nuts (14)* 3/4"x1.5" Bolts (14)
Parts
No parts specified.
-
-
You need to make 4 of these.
-
Center a leg holder on the 1/4x8x8 plate, ensuring it is square in all directions.
-
Weld it 100% to the plate.
-
-
-
You need two and they are exactly the same.
-
Punch the 3/4" holes
-
Place the leg holders in their proper locations.
-
They go on the 4" side of the angle.
-
Make sure they are square with the angle iron and centered vertically.
-
Weld them to the angle.
-
-
-
Mark all holes
-
Punch all holes.
-
Label each arm with either "right" or "left"
-
